6ES7322-1BF01-0AA0 SM322, 8DO, 24V DC, 2A

Product Code: 6ES7322-1BF01-0AA0

Availability: In Stock

Price: $110.29
  
 
Artikelnummer 6ES7322-1BF01-0AA0
SIMATIC S7-300, DIGITAL OUTPUT SM 322, OPTICALLY ISOLATED, 8 DO, 24V DC, 2A, 1 X 20 PIN
Supply voltage
Load voltage L+
● Rated value (DC) 24 V
● permissible range, lower limit (DC) 20.4 V
● permissible range, upper limit (DC) 28.8 V
Input current
from load voltage L+ (without load), max. 60 mA
from backplane bus 5 V DC, max. 40 mA
Power losses
Power loss, typ. 6.8 W
Digital outputs
Number of digital outputs 8
Limitation of inductive shutdown voltage to L+ (-48 V)
Switching capacity of the outputs
● Lamp load, max. 10 W
Load resistance range
● lower limit 12 Ω
● upper limit 4 kΩ
Output voltage
● for signal "1", min. L+ (-0.8 V)
Output current
● for signal "1" rated value 2 A
● for signal "1" permissible range for 0 to 40 °C, max. 2.4 A
● for signal "1" minimum load current 5 mA
● for signal "0" residual current, max. 0.5 mA
Switching frequency
● with resistive load, max. 100 Hz
● with inductive load, max. 0.5 Hz
● on lamp load, max. 10 Hz
Aggregate current of outputs (per group)
horizontal installation
— up to 40 °C, max. 4 A
— up to 60 °C, max. 4 A
vertical installation
— up to 40 °C, max. 4 A
Cable length
● Cable length, shielded, max. 1 000 m
● Cable length unshielded, max. 600 m
Interrupts/diagnostics/status information
Alarms
● Diagnostic alarm No
Diagnostic messages
● Diagnostics No
● Wire break No
● Short circuit No
● Fuse blown No
● Missing load voltage No
Diagnostics indication LED
● Rated load voltage PWR (green) No
● Fuse OK FSG (green) No
Galvanic isolation
Galvanic isolation digital outputs
● between the channels, in groups of 4
● between the channels and the backplane bus Yes; Optocoupler
Isolation
Isolation checked with 500 V DC
Connection method
required front connector 20-pin
Dimensions
Width 40 mm
Height 125 mm
Depth 120 mm
Weights
Weight, approx. 190 g
last modified: 25.09.2014

Write a review

Note: HTML is not translated!

Rating: Bad Good

Enter the code in the box below: