6ES7131-4BB00-0AB0 SIMATIC DP, 5 ELECTRON. MODULES

6ES7131-4BB00-0AB0 SIMATIC DP, 5 ELECTRON. MODULES

Product Code: 6ES7131-4BB00-0AB0

Availability: In Stock

Price: $87.00
Qty:
Add to Wish List
Add to Compare
  
 
Digitalausgabemodul 2DO

-
SIMATIC DP, 5 ELECTRON. MODULES FOR ET 200S, 2 DI HIGH FEATURE 24V DC, 15 MM WIDTH WITH PARAM. F. INPUT DELAY DIAGNOSIS F. ENCODER SHORT- CIRCUIT W. LED SF (GROUP FAULT) 5 PIECES PER PACKAGING UNIT
Supply voltage
24 V DC Yes; From power module
Reverse polarity protection Yes
Input current
from backplane bus 3.3 V DC, max. 10 mA
from supply voltage L+, max. Dependent on encoder
Encoder supply
Output voltage min. L+ (-0.5 V), under load
short-circuit protection Yes; Electronic
Output current
Output current, rated value 500 mA
Output current, permissible range 0 to 500 mA
Power losses
Power loss, typ. 0.4 W
Address area
Address space per module
with packing 2 bit
without packing 1 byte
Digital inputs
Number of digital inputs 2
Input characteristic curve in accordance with IEC 61131, type 1 Yes
Input voltage
Rated value, DC 24 V
for signal "0" -30 to +5 V
for signal "1" 11 to 30 V
Input current
for signal "1", typ. 8 mA
Input delay (for rated value of input voltage)
for standard inputs
Parameterizable Yes; 0.1 / 0.5 / 3 / 15 ms
at "0" to "1", min. 0.05 ms
at "0" to "1", max. 15.15 ms
at "1" to "0", min. 0.05 ms
at "1" to "0", max. 15.15 ms
Cable length
Cable length, shielded, max. 1000 m
Cable length unshielded, max. 600 m
Encoder
Connectable encoders
2-wire sensor Yes
Permissible quiescent current (2-wire sensor), max. 1.5 mA
Isochronous mode
Isochronous operation (application synchronized up to terminal) Yes
Interrupts/diagnostics/status information
Alarms
Hardware interrupt Yes; Parameterizable
Diagnostic messages
Diagnostic information readable Yes
Short circuit Yes; Short-circuit of outputs to ground; module by module
Diagnostics indication LED
Group error SF (red) Yes
Status indicator digital input (green) Yes
Parameter
Remark 3 byte
Diagnosis: short circuit Disable / enable
Galvanic isolation
Galvanic isolation digital inputs
between the channels No
between the channels and the backplane bus Yes
Permissible potential difference
between different circuits 75 VDC / 60 VAC
Isolation
Isolation checked with 500 V DC
Dimensions
Width 15 mm
Height 81 mm
Depth 52 mm
Weights
Weight, approx. 35 g
Status Jun 16, 2014

Write a review

Note: HTML is not translated!

Rating: Bad Good

Enter the code in the box below:

Continue