6ES7132-0HF00-0XB0 ET200B, EL-BLOCK, 16DO, AC 230V, 0.5A

Product Code: 6ES7132-0HF00-0XB0

Availability: In Stock

Price: $455.53
Qty:
Add to Wish List
Add to Compare
  
 
SIMATIC DP, DIGITAL ELECTRONIC SUBMODULE FOR ET200B W=235MM, 16DO, 120/230V AC,0.5A
Input current
from supply voltage L1, max. 150 mA
Power losses
Power loss, max. 11 W
Hardware configuration
Rack
Required terminal block TB6/AC
Digital outputs
Number of digital outputs 16
Size of motor starter, max. Size 3 to NEMA
Short-circuit protection No
Controlling a digital input Yes
Switching capacity of the outputs
Lamp load, max. 25 W
Output voltage
Rated value (AC) 120/230 V AC
Output current
for signal "1" permissible range for 0 to 60 °C, min. 0.5 A; in groups of 4
for signal "0" residual current, max. 1.3 mA
Parallel switching of 2 outputs
for logic links Yes
for increased power No
for redundant control of a load Yes
Switching frequency
with resistive load, max. 10 Hz
with inductive load, max. 0.5 Hz
on lamp load, max. 1 Hz
Cable length
Cable length unshielded, max. 600 m
Interfaces
PROFIBUS DP
Transmission rate, max. 12 Mbit/s
Communication functions
Bus protocol/transmission protocol PROFIBUS DP
Interrupts/diagnostics/status information
Diagnostics indication LED
Bus fault BF (red) Yes
Run mode RUN (green) Yes
Status indicator digital output (green) Yes
Galvanic isolation
between electronic block and PROFIBUS DP Yes; 500 V DC to the logic, 1500 V AC to connecting terminals
Galvanic isolation digital outputs
Galvanic isolation digital outputs Yes; Optocoupler
between the channels, in groups of 4
Degree and class of protection
IP20 Yes
Ambient conditions
Operating temperature
horizontal installation, min. 0 °C
horizontal installation, max. 60 °C; 40°C for other mountings
Air pressure
permissible range, min. 795 hPa
permissible range, max. 1080 hPa
Relative humidity
Operation, min. 15 %
max. relative humidity 95 %; RH class 2 in accordance with IEC 1131-2
Vibrations
Operation, checked according to IEC 60068-2-6 Yes; IEC 68, Part 2-6; 10 to 57 Hz; (constant amplitude 0.075 mm); 57 to 150 Hz; (constant acceleration 1 g)
Shock test
checked according to IEC 60068-2-27 Yes; IEC 68, Part 2-27; half-sine, 15 g, 11 ms
Connection method
Inputs/outputs Screw-type and spring-loaded terminals, permanent wiring; 3 and 4-wire connection
Dimensions
Width 235 mm; EB and TB
Height 130 mm; EB and TB
Depth 60 mm; EB and TB
Weights
Weight, approx. 805 g; EB and TB
Status Jun 9, 2014

Write a review

Note: HTML is not translated!

Rating: Bad Good

Enter the code in the box below:

Continue