6ES7153-2BA01-0XB0 ET200M, INTERFACE IM153-2 HF

Product Code: 6ES7153-2BA01-0XB0

Availability: In Stock

Price: $245.92
  
 
Artikelnummer 6ES7153-2BA01-0XB0
SIMATIC DP, ET 200M INTERFACE IM 153-2 HIGH FEATURE FOR MAX. 8 S7-300 MODULES, WITH REDUNDANCY, TIME STAMPING FIT FOR ISOCHRONE MODE
General information
Vendor identification (VendorID) 801Eh
Supply voltage
24 V DC Yes
permissible range (ripple included), lower limit (DC) 20.4 V
permissible range (ripple included), upper limit (DC) 28.8 V
External protection for supply cables (recommendation) 2,5 A
Mains buffering
● Mains/voltage failure stored energy time 5 ms
Input current
Current consumption, max. 470 mA
Inrush current, typ. 3.5 A
I²t 0.08 A²·s
Power losses
Power loss, typ. 4 W
Address area
Addressing volume
● Inputs 128 byte
● Outputs 128 byte
Hardware configuration
Number of modules per DP slave interface, max. 8
Time stamping
Accuracy 1 ms
Number of message buffers 15
Number of stampable digital inputs, max. 128
Time format RFC 1119 Internet (ISP)
Time resolution 0.466 ns
Time stamp on signal change 1
Interfaces
Interface physics, RS 485 Yes
PROFIBUS DP
● Node addresses 1 to 125
● Automatic detection of transmission speed Yes
● PROFIBUS DP, output current, max. 70 mA
● Transmission rate, max. 12 Mbit/s
● Transmission procedure RS 485
● SYNC capability Yes
● FREEZE capability Yes
● Direct data exchange (slave-to-slave communication) Yes; only with F- DO
● PROFIBUS DP 9-pin sub D
1st interface
DP slave
● GSD file SI03801E.GSG
● Automatic baud rate search Yes
Communication functions
Bus protocol/transmission protocol PROFIBUS DP
Degree and class of protection
Degree of protection to EN 60529
● IP20 Yes
Ambient conditions
Operating temperature
● Min. 0 °C
● max. 60 °C
Air pressure
● Operating altitude above sea level, max. 3 500 m
Configuration
Configuration software
● STEP 7 Yes
Dimensions
Width 40 mm
Height 125 mm
Depth 117 mm
Weights
Weight, approx. 350 g
last modified: 18.09.2014

Write a review

Note: HTML is not translated!

Rating: Bad Good

Enter the code in the box below: