 |
SIMATIC S7, ANALOG OUTPUT SM 332, OPTICALLY ISOLATED, 4 AO, 0/4 UP TO 20 MA, 20 PIN, FOR SIGNALS FROM HAZARDOUSAREAS CAPABLE OF DIANOST., PTB-TESTED |
| Supply voltage |
| Load voltage L+ |
| ● Rated value (DC) |
24 V |
| Input current |
| from load voltage L+ (without load), max. |
180 mA |
| from backplane bus 5 V DC, max. |
80 mA |
| Power loss |
| Power loss, typ. |
4 W |
| Analog outputs |
| Number of analog outputs |
4 |
| Voltage output, short-circuit protection |
Yes |
| Voltage output, short-circuit current, max. |
70 mA |
| Current output, no-load voltage, max. |
14 V |
| Output ranges, current |
| ● 0 to 20 mA |
Yes |
| ● 4 to 20 mA |
Yes |
| Connection of actuators |
| ● for current output two-wire connection |
Yes |
| Load impedance (in rated range of output) |
| ● with current outputs, max. |
500 Ω |
| Cable length |
| ● Cable length, shielded, max. |
200 m |
| Analog value generation |
| Integration and conversion time/resolution per channel |
| ● Resolution with overrange (bit including sign), max. |
15 bit |
| ● Basic conversion time, ms |
2,5 ms |
| Errors/accuracies |
| Operational error limit in overall temperature range |
| ● Current, relative to output area, (+/-) |
0.55 % |
| Basic error limit (operational limit at 25 °C) |
| ● Current, relative to output area, (+/-) |
0.2 % |
| Interrupts/diagnostics/status information |
| Diagnostic messages |
| ● Diagnostic functions |
Yes |
| ● Diagnostic information readable |
Yes |
| ● Overrange |
Yes |
| ● Wire-break in actuator cable |
Yes |
| ● Group error |
Yes |
| Diagnostics indication LED |
| ● Short-circuit per channel (red) |
Yes |
| ● Short-circuit group error (red) |
Yes |
| Ex(i) characteristics |
| Module for Ex(i) protection |
Yes |
| Galvanic isolation |
| Galvanic isolation analog outputs |
| ● Galvanic isolation analog outputs |
Yes |
| Permissible potential difference |
| between outputs and MANA (UCM) |
60 V DC/30 V AC when used in the hazardous area; 400 V DC/250 V AC when used in NON-hazardous area |
| between the outputs (UCM) |
60 V DC/30 V AC when used in the hazardous area; 400 V DC/250 V AC when used in NON-hazardous area |
| Standards, approvals, certificates |
| Use in hazardous areas |
| ● Type of protection acc. to EN 50020 (CENELEC) |
[EEx ib] IIC |
| ● Type of protection acc. to FM |
Class I, Division 2, Group A, B, C, D T4 |
| ● Test number PTB |
Ex-96.D.2026X |
| Ambient conditions |
| Operating temperature |
| ● max. |
60 °C |
| Connection method |
| required front connector |
20-pin |
| Weights |
| Weight, approx. |
280 g |
| last modified: |
21.08.2014 |
