6ES7322-8BH10-0AB0 SM322, 16DO, 24V DC, 0,5A

Product Code: 6ES7322-8BH10-0AB0

Availability: In Stock

Price: $100,000,000,000.00
Artikelnummer 6ES7322-8BH10-0AB0
SIMATIC S7/PCS7, SM 322 DIGITAL OUTPUT MODULE, 16 DO, DC 24 V / 0,5A, CAPABLE OF DIAGNOSTICS, WIRE BREAK DETECTION TO 0 AND 1 SIGNAL, 1 X 40-PIN, INTERFACE MODULE IM 153-X HF NECESSARY
Supply voltage
Load voltage L+
● Rated value (DC) 24 V
● permissible range, lower limit (DC) 20.4 V
● permissible range, upper limit (DC) 28.8 V
Input current
from load voltage L+ (without load), max. 100 mA
from backplane bus 5 V DC, max. 100 mA
Power losses
Power loss, typ. 6 W
Digital outputs
Number of digital outputs 16
Limitation of inductive shutdown voltage to L+ (-68 V)
Switching capacity of the outputs
● Lamp load, max. 5 W
Load resistance range
● lower limit 48 Ω
● upper limit 4 kΩ
Output voltage
● for signal "1", min. L+ (-0.7 V)
Output current
● for signal "1" rated value 0.5 A
● for signal "1" permissible range, min. 5 mA
● for signal "1" permissible range, max. 0.6 A
● for signal "0" residual current, max. 0.7 mA
Switching frequency
● with resistive load, max. 100 Hz
● on lamp load, max. 10 Hz
Aggregate current of outputs (per group)
horizontal installation
— up to 60 °C, max. 2 A
vertical installation
— up to 40 °C, max. 2 A
Cable length
● Cable length, shielded, max. 1 000 m
● Cable length unshielded, max. 600 m
Interrupts/diagnostics/status information
Alarms
● Diagnostic alarm Yes
Diagnostic messages
● Diagnostics Yes
● Wire break Yes
● Short circuit Yes
● Missing load voltage Yes
Diagnostics indication LED
● Rated load voltage PWR (green) No
Galvanic isolation
Galvanic isolation digital outputs
● between the channels, in groups of 4
● between the channels and the backplane bus Yes
Isolation
Isolation checked with 500 V DC
Connection method
required front connector 1x 40-pin
Dimensions
Width 40 mm
Height 125 mm
Depth 120 mm
Weights
Weight, approx. 350 g
last modified: 13.10.2014

Write a review

Note: HTML is not translated!

Rating: Bad Good

Enter the code in the box below: